Christie D4KLH60 Mirage 4KLH Installation Manual page 38

1. Loosen the mounting arm on the TPC.
2. Place the base of the TPC mounting arm over the ball joint (A) located on the rear panel of the
projector.
3. Tighten the mounting arm until it fits snugly on the ball joint.
4. Connect the cable from the TPC to the connector on the rear panel of the projector.
5. Tilt the TPC to adjust the viewing angle.
D4KLH60/Mirage 4KLH Installation Guide
020-101374-01 Rev. 1 (05-2014)
A
Installation
38