Table of Contents
Advertisement
Connect the interlock to the projector
1. Attach the female connector of the longest 9-pin Interlock cable to the Interlock IN connector
of the bottom laser module in the laser rack.
See
Connect the interlock cables to the laser modules
2. Connect the male connector of the cable to the Laser Interlock connector at the back of the
projector.
Connect the laser rack harness
1. Connect the 25-pin laser rack harness to the laser rack connector at the back of the projector.
Connect the Ethernet cable to the projector
1. Remove the bottom cover of the touch pad controller.
2. Connect the Ethernet cable to the connector at the bottom of the TPC.
3. Replace the bottom cover feeding the cable through the opening.
4. Connect the other end of the Ethernet cable to the laser system network switch.
CP42LH Installation Guide
020-101373-02 Rev. 1 (06-2015)
on page 34.
Installation
47
Advertisement
Table of Contents
