Position And Set Up The Laser Rack - Christie D4KLH60 Mirage 4KLH Installation Manual

Position and set up the laser rack

Failure to comply with the following could result in death or serious injury.
• Two people are required to set up the laser rack.
• Always load the laser modules into the laser rack from the bottom up.
• Laser rack must be positioned with the front completely visible and with the operator side
1. Remove the laser rack from the packaging and stand it upright so the front, back, and operator
side are accessible.
2. Move the adjustable feet up and down until the laser rack is level, then lock the feet in position.
3. If required for local building and safety regulations, secure the laser rack to the floor with
mounting brackets.
4. Unlock the front and rear access doors with the two security keys provided.
5. Remove each door by tilting it toward you and lifting high enough to clear the locating pins at
the bottom of the rack, then set them aside.
6. Remove the three fiber carrier panels on the operator side and set them aside.
7. If you route the fiber optic overhead, remove the four M4 screws securing the top access cover.
8. If you route the fiber optic cable on the floor, remove the four M4 screws securing the bottom
access cover.
D4KLH60/Mirage 4KLH Installation Guide
020-101374-01 Rev. 1 (05-2014)
(right side when facing the front) accessible.
Installation
28