Table of Contents
Advertisement
x = 0.312, y = 0.329
For more precise adjustments, click the cap on the slider and press the up and down arrow
keys.
6. Repeat steps 4 to 5 until the measured values are approximately the same as the target white
point.
Save the laser settings
1. On the System tab under Configuration Management, click Save.
2. Type a name for the settings file and press Enter.
Add the projector to a network
1. On the TPC, tap Menu > Communications > Ethernet Settings > Modify IP Settings.
2. To obtain the IP address automatically, tap Automatic then Ok.
3. To specify the settings, tap Manual, type the IP Address, Subnet Mask, and Gateway (optional),
then tap Ok.
Turn system off
1. On the TPC on the projector, tap and hold Power.
Turn system off in an emergency
1. Press the E-Stop button either on the back of the projector (see
page 23) or on the operator side of the Laser Rack (see
to shut down the laser modules.
The laser modules turn off.
D4KLH60/Mirage 4KLH Installation Guide
020-101374-01 Rev. 1 (05-2014)
Adjust the Image
Projector safety features
Laser rack safety features
on
on page 22)
68
Advertisement
Table of Contents
