Table of Contents
Advertisement
The physical layout of the Formatter boards dictates the behavior of the twist and vertical
adjustments:
•
The adjustment is like a "Twist with the left-side of the screen as a sliding hinge point to allow
vertical travel".
•
The vertical adjustment screw and twist adjustment screw interact with each other such that if
one is turned in the opposite direction of the other, the twist is affected.
•
If both screws are turned equal amounts in the same direction, the image moves vertically.
•
Remove the light engine air filter and fan pack to access the blue convergence adjustment
screws.
Cooling is affected by removing the filter and fan pack assembly.
You do not always have to turn the screws simultaneously; however, adjusting one at a time
requires equal or equal and opposite turn on the other to prevent binding and achieve the required
adjustment. It is recommended to locate the shorter blade 2.5 mm driver on adjusting screw #2
(especially on the red), and use the longer blade 2.5 mm driver for screw#1 and horizontal (screw
#3).
D4KLH60/Mirage 4KLH Installation Guide
020-101374-01 Rev. 1 (05-2014)
Adjust the Image
65
Advertisement
Table of Contents
