Table of Contents
Advertisement
Adjust the Image
Always follow the laser safety regulations when completing any mechanical adjustments.
Turn the laser power down to a safe level before opening the projector. Failure to comply
could result in death or serious injury.
For optimum results, follow the procedures in this section in the order that they appear. Do not
complete procedures out of order. Image adjustment is an iterative process.
Turn the system on
1. Check the interlock cables are securely attached to the laser modules.
2. Check the interlock cable to the projector is securely attached.
3. Check the Ethernet cable between the projector and the laser system network switch is
securely attached.
4. Check the Ethernet cable between the laser bank manager and the laser system network switch
is securely attached.
5. Turn on the laser bank manager.
6. Turn on the circuit breaker on the projector baseplate under the front lens-side corner.
7. If the emergency-stop button on either the Laser Rack or the projector is activated, release it
by turning the button clockwise.
8. Turn the Beam Stop on the projector to OPEN.
9. Turn the Laser Rack key switch on.
The key must be in the switch at all times.
10. Turn on the laser system network switch at the rear of the Laser Rack.
11. Turn on the breakers (one per laser module) in the power distribution unit in the front of the
Laser Rack.
12. Press MANUAL RESET on the side of the Laser Rack or on the back of the projector.
Wait for a few seconds for the interlock to close and the laser emission status lights on the rear
of the projector to turn on.
13. To turn on the projector, on the Home tab on the touch panel controller (TPC), tap Power.
14. Verify the status lights on the back of the projector and the front of the laser modules are
white.
D4KLH60/Mirage 4KLH Installation Guide
020-101374-01 Rev. 1 (05-2014)
51
Advertisement
Table of Contents
