Table of Contents
Advertisement
•
Christie Digital Systems Mirage 4KLH Series projector
•
3D stereo sync cable (for Direct-Input 3D)
•
A source, usually a computer with a 3D graphics card(s)
•
Emitter for controlling active shutter glasses
or
A qualified device that mounts in front of the lens of the project to process the light from the
lens into a passive polarized light. Contact your Immersive dealer for more information.
Software and content requirements
Note the following software and content requirements for stereo 3D applications:
•
Any 3D computer software application that supports 3D stereo on a supported computer(s) with
associated graphic cards (suggested cards include AMD or NVIDIA)
•
A video stream from a video source prepared to be sequential content (for Direct-Input 3D) or
two video streams from a video source that has been prepared to be supplied left eye and right
eye concurrently and frame locked (Dual-Input 3D)
Active stereo 3D configuration
The following diagram shows the typical hardware configuration for active stereo 3D systems:
In response to the 3D Sync Out signal from the projector, the IR emitter emits an infrared
signal to a receiver in the active 3D shutter glasses. This synchronizes the active glasses to
alternatively open and close for the active stereo 3D applications.
D4KLH60/Mirage 4KLH Installation Guide
020-101374-01 Rev. 1 (05-2014)
Installation
43
Advertisement
Table of Contents
