Table of Contents
Advertisement
Slot 2
1-In
Slot 2
2-In
Four-Port Input Configuration (2)
Slot 3
1-In
Slot 3
2-In
Slot 4
1-In
Slot 4
2-In
DDIC card
The following table shows the video quadrant mappings for the DDIC Four-Port input configuration:
Four-Port Input Configuration
Slot 1
1-Dual Link DVI-I
Slot 2
1-Dual Link DVI-I
Slot 3
1-Dual Link DVI-I
Slot 4
1-Dual Link DVI-I
Connect devices to the 3D sync ports
The 3D Sync Input and Output ports located on the MCPU faceplate provide a convenient method
for interfacing the projector to the 3D stereo projection system. The 3D Sync Input should be
connected to the 3D video source for synchronization of the left eye/right eye frames. The 3D Sync
Output is available for control of an IR Emitter for active glasses or a polarization device for passive
glasses.
Master CPU Module 108-452102-01
Power
Connect a computer or server
To communicate with a remote computer, server, or an existing network, use an RJ45 cable to
connect the Ethernet hub or switch to the Ethernet port, located on the projector MCPU faceplate.
When using the Christie serial protocol over Ethernet, connect to port 3002.
D4KLH60/Mirage 4KLH Installation Guide
020-101374-01 Rev. 1 (05-2014)
Top right
Bottom right
Top left
Bottom left
Top right
Bottom right
Top left
Top right
Bottom left
Bottom right
3D Sync
OUT
IN
USB
Ethernet
R 232 IN
S
Network
DHCP
R 232 OUT
S
Reset
Installation
R 422
S
GPIO
49
Advertisement
Table of Contents
