Table of Contents
Advertisement
5. If you need to adjust the vertical or horizontal position more than the feet a allow, install the
foot extension rods. See
6. Tighten the projector feet lock nuts.
Adjust lens offset, rather than extra projector tilt, if vignetting is not observed.
Install the foot extension rods
Failure to comply with the following could result in death or serious injury.
• Use of the rear safety strap on the projector is mandatory to prevent the projector from
• Two people are needed to safely perform this procedure.
If you need to adjust the vertical or horizontal position of the projector beyond what the standard
feet allow, install the foot extension rods.
1. Prop up the rear of the projector to access the two rear feet.
2. Remove the feet by loosening the lock nut and rotating the each foot out of the projector.
3. Add the extension rods to the standard feet.
4. Thread the extended feet into the projector's baseplate.
5. Adjust the feet until the required tilt is achieved.
Lock the feet in place by turning each lock nut until it fits tight against the projector.
Install the touch panel controller
Note that the touch panel controller (TPC) supplied with the Christie Laser Projection System is
different from the TPC for lamp-based projectors.
D4KLH60/Mirage 4KLH Installation Guide
020-101374-01 Rev. 1 (05-2014)
Install the foot extension rods
tipping. Secure the strap between the projector and the optional rack stand or another
structure.
1
on page 37.
2
19 mm
Installation
3
37
Advertisement
Table of Contents
