Connecting The Shared Port Adapter Cables; Connecting The Console And Auxiliary Port Cables - Cisco ASR 1000 series Hardware Installation Manual

Chapter 7 Cisco ASR 1004 Router Overview and Installation
Using the bottom rack-mount ear hole, insert the screw through cable-management bracket and into the
Step 3
chassis rack-mount (see
This completes the procedure for installing the cable-management brackets on the chassis in a rack.

Connecting the Shared Port Adapter Cables

The instructions for connecting the cables for the shared port adapter installed in the Cisco ASR 1004
Router are contained in the respective configuration documents for each port adapter. For example, if
you are connecting the optical fiber cables for the PA-POS-OC3 port adapter, see PA-POS-OC3 Port
Adapter Installation and Configuration at the following location:
http://www.cisco.com/en/US/partner/docs/interfaces_modules/port_adapters/install_upgrade/pos/pa-po
s-oc3_install_config/paposoc3.html

Connecting the Console and Auxiliary Port Cables

The Cisco ASR 1004 Router has a DCE-mode console port for connecting a console terminal and an
auxiliary port for additional connections to your chassis. The auxiliary port can also be used for
diagnostics.
.
Figure 7-15
1
The Cisco ASR 1004 Router uses RJ-45 ports for both the auxiliary port and the console port. Both the
console and the auxiliary ports are asynchronous serial ports; any devices connected to these ports must
be capable of asynchronous transmission.
For console and auxiliary port pinouts for the RJ-45 connector, see
Specifications" section on page
Before connecting a terminal to the console port, configure the terminal to match the chassis console
Step 1
port as follows: 9600 baud, 8 data bits, no parity, 1 stop bits (9600 8N1).
OL-13208-11
Figure
Figure 7-15 shows the CON and AUX ports on the Cisco ASR 1000 Series route processor.
Cisco ASR 1000 Series Route Processor—CON and AUX Ports
CR IT
MA J
ACT V
PW R
MIN
STB Y
STA T
P1
AS R1 00 0-R
Console port - CON
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
7-14).
SPA -4XO C3-P OS
OS
SPA -4XO C3-P
LIN K
ERN ET
HD CA RR IER MGM T ETH
BIT S
USB
DF
DIS K
1
0
2
Auxiliary port - AUX
A-491. Both ports are configured as asynchronous serial ports.
Connecting the Shared Port Adapter Cables
1 2
OS
SPA -4XO C3-P
AUX
CO N
"Cisco ASR 1004 Router
7-21