Attaching A Chassis Ground Connection - Cisco ASR 1000 series Hardware Installation Manual

Chapter 7 Cisco ASR 1004 Router Overview and Installation
Figure 7-11
2
1
2
Finger-tighten 4 more screws to the rack rails on each side of the chassis.
Step 4
Tighten all screws on each side to secure the chassis to the equipment rack.
Step 5
Use a level to verify that the tops of the two brackets are level, or use a measuring tape to verify that both
Step 6
brackets are the same distance from the top of the rack rails.
This completes the procedure for installing the chassis in the rack. Proceed to the
Ground Connection" section on page 7-17

Attaching a Chassis Ground Connection

Connecting the Cisco ASR 1004 Router chassis to ground is required for all DC powered installations
and any AC powered installation where compliance with Telcordia grounding requirements is necessary.
The dual-lug chassis ground stud must be installed, the SIP and SPA must be fully inserted and screwed
Caution
in and earthed to prevent a potential hazard in a telecom line.
OL-13208-11
Cisco ASR 1004 Router on a Four-Post Rack—Front and Rear Rack-Mounting
1
Equipment rack rear rail
Chassis rear rack-mount bracket and ear holes 4
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
HD
USB
CRIT
DF
MAJ
ACTV
DISK
PWR
MIN 1
STBY 0
STAT
ASR 1000 -RP 1
3
4
3 Front rack-mount bracket ear and holes
Equipment rack front rail
to continue the installation.
Attaching a Chassis Ground Connection
-POS
SPA-4 XOC3
SPA-4 XOC3 -POS
SPA-4 XOC3 -POS
-POS -POS
SPA-4 XOC3 SPA-4 XOC3
-POS
SPA-4 XOC3
SPA-4 XOC3 -POS
SPA-4 XOC3 -POS
AUX
LINK CON
NET
CARR IER MGMT ETHER
BITS
"Attaching a Chassis
7-17