Cisco Asr 1002 Router Power Supplies - Cisco ASR 1000 series Hardware Installation Manual

Cisco ASR 1002 Router Power Supplies

Insert the other end of the RJ-45 cable to your management device or network.
Step 2
Cisco ASR 1002 Router Power Supplies
This section describes the Cisco ASR 1002 Router power supplies and how to connect them:
•
•
•
Read the safety warnings before you begin.
Warning The covers are an integral part of the safety design of the product. Do not operate the unit without the
covers installed. Statement 1077
When you install the unit, the ground connection must always be made first and disconnected last.
Warning
Statement 1046
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Warning
Statement 1003
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Warning Never install an AC power module and a DC power module in the same chassis. Statement 1050
Warning Installation of the equipment must comply with local and national electrical codes. Statement 1074
When installing or replacing the unit, the ground connection must always be made first and
Warning
disconnected last. Statement 1046
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
This unit has two power supply connections. All connections must be removed to de-energize the unit.
Warning
Statement 1028
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
8-32
Connecting AC Input Power to Cisco ASR 1002 Router, page 8-33
Connecting –48 VDC Input Power to Cisco ASR 1002 Router, page 8-35
Connecting Cisco +24 VDC Power Supply, page 8-38
Chapter 8 Cisco ASR 1002 Router Overview and Installation
OL-13208-11