Cisco ASR 1000 series Hardware Installation Manual page 457

Chapter 14 Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Hold the DIMM component-side up, with the connector edge (the metal fingers) closest to you. Hold the
Step 4
ends of the DIMM between your thumb and forefinger. See
Figure 14-18
Tilt the DIMM to approximately the same angle as the socket and insert the connector edge into the
Step 5
socket. Note the two notches (keys) on the connector edge of the DIMM. These keys are intended to
ensure correct orientation of the DIMM in the socket.
When inserting DIMMs, use firm but not excessive pressure. If you damage a socket, you will have to
Caution
return the route processor to the factory for repair.
Note the orientation of the socket key on the DIMM and the DIMM socket and gently push the DIMM
Step 6
into the socket until the lever is flush against the side of the DIMM socket, and the DIMM edge
connector is fully inserted. If necessary, rock the DIMM gently back and forth to seat it properly.
Figure 14-19
Figure 14-19
When the DIMM is installed, check that the release lever is flush against the side of the DIMM socket.
Step 7
If it is not, the DIMM might not be seated properly. If the DIMM appears misaligned, carefully remove
it according to the removal procedure and then reseat it in the socket. Push the DIMM firmly back into
the socket until the release lever is flush against the side of the DIMM socket.
Repeat Step 3 through Step 7 for the remaining DIMMs.
Step 8
Replace the Cisco ASR1000-RP2.
Step 9
OL-13208-11
Handling the Cisco ASR1000-RP2 DIMM
Key
shows how to install the DIMM in the socket.
Installing the DIMM in the Socket
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
Removing and Replacing the Cisco ASR 1000 Series DIMM Memory Modules
Figure 14-18.
14-27