Cisco ASR 1000 series Hardware Installation Manual page 234

Attaching a Chassis Ground Connection
Before you connect power or turn on power to your chassis, you must provide an adequate chassis ground
(earth) connection for the chassis. The chassis ground lug (two) and the respective screws (four) are
provided in the accessory kit that ships with your Cisco ASR 1002 Router.
The grounding wire is always the first to be installed or connected and the last to be removed or
Caution
disconnected.
The following tools, equipment, and supplies necessary to connect the system ground to the chassis:
Phillips screwdriver
•
Dual-lug chassis ground component (two) and respective screws (four) (shipped with the accessory
•
kit)
Grounding wire
•
Figure 8-17
Figure 8-17
4
1 F0 with ASR1000-ESP5 or ESP10.
2
R0 slot with embedded ASR1000-RP1 and
embedded ASR1000-SIP10.
To attach the grounding lug to the chassis ground connector on your chassis, follow these steps:
Use the wire stripper to strip one end of the AWG #6 wire approximately 0.75 inches (19.05 mm).
Step 1
Step 2 Insert the AWG #6 wire into the wire receptacle on the grounding lug. Use the manufacturers's
recommended crimping tool to carefully crimp the wire receptacle around the wire; this step is required
to ensure a proper mechanical connection.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
8-28
shows the location of the dual ground lug on the side of the of Cisco ASR 1002 Router.
Cisco ASR 1002 Router Chassis Ground Lug Location and Side Panel Door
3
Chapter 8 Cisco ASR 1002 Router Overview and Installation
PWR STAT
CON
AUX
MGMT
LINK
MTS
CARR IER
BOOT
QE3
QE2
QE1
QE0
STAT
AS R 100 2
min
stat
maj
pwr
SPA-4 XOC3- POS
crit
3 The eUSB panel door on the side of the Cisco
ASR 1002 Router must not be opened. If there
is a problem with eUSB flash card, the chassis
should be returned.
4
Cisco ASR 1002 Router ground stud location.
1
2
SPA-4 XOC3- POS
SPA-4 XOC3- POS
OL-13208-11