Cisco ASR 1000 series Hardware Installation Manual page 269

Chapter 9 Cisco ASR 1002-F Router Overview and Installation
Figure 9-11
1
2
Screw the cable-management brackets to each side of the rack-mount brackets already attached to the
Step 8
chassis. Use two screws for each cable-management bracket.
Check that all the screws are securely tightened.
Step 9
Go to the
Rack-Mounting the Cisco ASR 1002-F Router
The Cisco ASR 1002-F Router can be installed in an existing rack with equipment or in an empty rack
with no equipment. The chassis can be mounted in two equipment rack types:
•
•
The Cisco ASR 1002-F Router can be installed with both front or rear rack-mount brackets.
OL-13208-11
Attaching the Cable-Management Brackets to the Cisco ASR 1002-F Router
3
1
Cable-management bracket top screw hole
and bottom screw hole
Cable-management bracket "U" feature
"Attaching a Chassis Ground Connection" section on page 9-23
Two-post rack, 19-inch or 23-inch equipment rack. Inner clearance (the width between the inner
sides of the two posts or rails) must be at least 19 inches (48.26 cm). The height of the chassis is
3.47 inches (8.8 cm). Airflow through the chassis is from front to back.
If you are using a two-post rack, secure the rack to the floor surface to prevent tipping and
Note
avoid bodily injury.
Four-post, 19-inch equipment rack. Inner clearance (the width between the inner sides of the two
posts or rails) must be at least 19 inches (48.26 cm). The height of the chassis is 3.47 inches/8.8 cm).
Airflow through the chassis is from front to back.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
Rack-Mounting the Cisco ASR 1002-F Router
0
3 Chassis front rack-mount bracket
—
—
C3 -PO S
SP A-4 XO
2
to continue the installation.
9-15