Cisco ASR 1000 series Hardware Installation Manual page 401

Chapter 12 Cisco ASR 1001 Router Overview and Installation
Align the cable-management bracket to the rack-mount bracket on one side of the Cisco ASR 1001
Step 1
Router. The cable-management bracket aligns to the top hole of the chassis rack-mount bracket.
Using a Phillips screwdriver, insert the screw through cable-management bracket and into the chassis
Step 2
rack-mount and tighten the screw.
Note
Figure 12-18
rack.
Figure 12-18
1
1
Using the bottom rack-mount ear hole, insert the screw through cable-management bracket and into the
Step 3
chassis rack-mount (see
This completes the procedure for installing the cable-management brackets on the chassis.
Attaching a Chassis Ground Connection
Connecting the Cisco ASR 1000 Series Router to ground is required for all DC powered installations
and any AC powered installation where compliance with Telcordia grounding requirements is necessary.
The dual-lug chassis stud must be installed, the SIP and SPA must be fully inserted and screwed in and
Caution
earthed to prevent a potential hazard in a telecom line.
Have the recommended tools and supplies available before you begin this procedure.
OL-13208-11
Use the package of screws that came with your chassis containing four screws.
shows where to attach the front rack-mount brackets to the Cisco ASR 1001 Router in a
Chassis Rack-Mount Bracket Ear Holes for the Cable-Management Bracket
Secure the cable-management screw to the middle ear hole of the front rack-mount bracket on
both sides of the Cisco ASR 1001 Router.
Figure
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
1
12-18).
Attaching a Chassis Ground Connection
12-27