Connecting The Shared Port Adapter Cables; Connecting The Console And Auxiliary Port Cables - Cisco ASR 1004 Install Manual

Chapter 7 Cisco ASR 1004 Router Overview and Installation
Using the bottom rack-mount ear hole, insert the screw through cable-management bracket and into the
Step 3
chassis rack-mount (see
This completes the procedure for installing the cable-management brackets on the chassis in a rack.

Connecting the Shared Port Adapter Cables

The instructions for connecting the cables for the shared port adapter installed in the Cisco ASR 1004
Router are contained in the respective configuration documents for each port adapter. For example, if
you are connecting the optical fiber cables for the PA-POS-OC3 port adapter, see PA-POS-OC3 Port
Adapter Installation and Configuration at the following location:
http://www.cisco.com/en/US/partner/docs/interfaces_modules/port_adapters/install_upgrade/pos/pa-po
s-oc3_install_config/paposoc3.html

Connecting the Console and Auxiliary Port Cables

The Cisco ASR 1004 Router has a DCE-mode console port for connecting a console terminal and a
DTE-mode auxiliary port for connecting a modem or other DCE device (such as another router) to your
chassis.
.
Figure 7-15
1
Both the console and the auxiliary ports are asynchronous serial ports; any devices connected to these
Note
ports must be capable of asynchronous transmission. (Asynchronous is the most common type of serial
device; for example, most modems are asynchronous devices.)
The Cisco ASR 1004 Router uses RJ-45 ports for both the auxiliary port and the console port.
For console and auxiliary port pinouts for the RJ-45 connector, see
Specifications" section on page
OL-13208-09
Figure
Figure 7-15 shows the CON and AUX ports on the Cisco ASR 1000 Series route processor.
Cisco ASR 1000 Series Route Processor—CON and AUX Ports
Console port - CON
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
7-14).
HD
USB
CR IT
DF
MA J
ACT V
DIS K
PW R
1
MIN 0
STB Y
STA T
P1
AS R1 00 0-R
2
Auxiliary port - AUX
A-5. Both ports are configured as asynchronous serial ports.
Connecting the Shared Port Adapter Cables
1 2
OS
SPA -4XO C3-P
OS
SPA -4XO C3-P
AUX
LIN K
CO N
ERN ET
MGM T ETH
CA RR IER
BIT S
"Cisco ASR 1004 Router
OS
SPA -4XO C3-P
7-21