Cisco ASR 1000 series Hardware Installation Manual page 280

Connecting the Shared Port Adapter Cables
Use the Number 2 Phillips screwdriver to carefully tighten the screws until the grounding lug is held
Step 6
firmly to the chassis. Do not overtighten the screws.
Step 7 Connect the opposite end of the ground wire to the appropriate grounding point at your site to ensure an
adequate chassis ground.
This completes the procedure for attaching a chassis ground connection. Go to the following cabling
sections for information on attaching cables.
Connecting the Shared Port Adapter Cables
The instructions for connecting the cables for the shared port adapter (SPA) installed in the Cisco
ASR 1002-F Router are contained in the respective configuration documents for SPAs. For detailed SPA
information, see
Installation
Connecting the Console and Auxiliary Port Cables
This section describes how to attach a cable to the Cisco integrated RP console or auxiliary ports on the
Cisco ASR 1002-F Router. The Cisco ASR 1002-F Router uses RJ-45 ports for both the auxiliary port
and console port to attach a console terminal.
To meet Class A emission requirements on the Cisco ASR 1002-F Router, shielded cables must be used
Caution
for the console and auxiliary port connectors.
Before you can use the console interface on the router using a terminal or PC, you must perform the
following steps:
Before connecting a terminal to the console port or auxiliary port, configure the terminal to match the
Step 1
chassis console port as follows: 9600 baud, 8 data bits, no parity, 1 stop bits (9600 8N1).
Connect to the port using an RJ-45 cable to a DB-9 cable.
Step 2
For information about how to change the default settings to meet the requirements of your terminal or
Note
host, see
see the
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
9-26
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware
Guide.
Cisco IOS Terminal Services Configuration
"Cisco ASR1000-RP2 Pinout Specifications" section on page
Chapter 9 Cisco ASR 1002-F Router Overview and Installation
Guide. For route processor pinout specifications,
B-507.
OL-13208-11