Cisco ASR 1000 series Hardware Installation Manual page 455

Chapter 14 Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
•
•
•
Table 14-3
Table 14-3
Memory PID Option
M-ASR1K-RP2-8GB=
M-ASR1K-RP2-16GB=
This section describes how to remove and then replace the Cisco ASR1000-RP2 module DIMMs (see
Figure
Figure 14-16 Cisco ASR1000-RP2 Module Internal Component Location
1
2
Removing the Cisco ASR1000-RP2 DIMMs
Follow these steps to remove the Cisco ASR1000-RP2 DIMMs:
OL-13208-11
Back up data that you want to save before replacing a eUSB device.
Note that the component is keyed and slotted for easier connection.
To ensure the DIMMs are functioning properly, all four DIMMs must be replaced at the same time
and must be of the same manufacturer and part number (since vendors may have multiple versions
of the DIMM).
shows the slots that are supported for inserting memory DIMMs in Cisco ASR1000-RP2
Cisco ASR1000-RP2 Supported Slots for Inserting Memory DIMMs
Slot 0
2 GB module
4 GB Module
14-16).
2
1
3
Internal hard drive location
Cisco ASR1000-RP2 DIMM location
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
Removing and Replacing the Cisco ASR 1000 Series DIMM Memory Modules
Slot 1 Slot 2
2 GB module 2 GB module
4 GB Module 4 GB Module
3 Cisco ASR1000-RP2 internal eUSB device
— —
Slot 3
2 GB module
4 GB Module
14-25