Cisco ASR 1000 series Hardware Installation Manual page 382

Cisco ASR 1001 Router Description
The following figures show the front panel of the Cisco ASR 1001 Router with the various IDCs.
Figure 12-6
Figure 12-6
ASR 1001
1 MAJ LED—major alarm indicator
2 CRIT LED—critical alarm indicator
3 USB port— one USB high-speed (480Mbps)
port used for secure key storage, storing of
VPN credentials, or bulk flash storage for
image and configuration backup
4 USB LED
5 LINK LED indicates MGMT Ethernet port
activity
Note For detailed descriptions of the SPAs on which some of the IDCs are based, go to:
http://www.cisco.com/en/US/products/ps6267/products_data_sheets_list.html
There are two field-replaceable units in the Cisco ASR 1001 chassis. They are the DIMMs and eUSB.
Note
In order to service the components in the chassis, you must remove the power supplies and the chassis
cover. For instructions, see the
Modules" section on page 13-400
1001 Router" section on page
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
12-8
shows the LEDs that are common to all configurations of the Cisco ASR 1001 Router.
Common LEDs for Cisco ASR 1001 Route Processor
1 2 3 4
CRIT
PWR
MAJ
MIN
STAT
8
9 7 6
"Removing and Replacing the Cisco ASR 1001 Router DIMM Memory
and the
13-414.
Chapter 12 Cisco ASR 1001 Router Overview and Installation
USB LINK
BF
5
6 BF—Internal bootflash LED indicates
activity of the EUSB device
7 MIN LED —minor alarm indicator
8 STAT—status LED
9 PWR—Power LED
— —
"Remove and Replace the eUSB Device on the Cisco ASR
OL-13208-11