Cisco ASR 1000 series Hardware Installation Manual page 319

Chapter 10 Cisco ASR 1002-X Router Overview and Installation
Insert the two screws through the holes in the grounding lug.
Step 6
Use the Number 2 Phillips screwdriver to carefully tighten the screws until the grounding lug is held
Step 7
firmly to the chassis. Do not overtighten the screws.
Connect the opposite end of the grounding wire to the appropriate grounding point at your site to ensure
Step 8
an adequate chassis ground.
This completes the procedure for attaching a chassis ground connection. Go to the following cabling
sections for information on attaching cables.
Connecting the SPA Cables
The instructions for connecting the SPA cables installed in the Cisco ASR 1002-X Router are contained
in the respective configuration documents for each port adapter. For example, if you are connecting the
optical fiber cables for the PA-POS-OC3 port adapter, see PA-POS-OC3 Port Adapter Installation and
Configuration at :
http://www.cisco.com/en/US/partner/docs/interfaces_modules/port_adapters/install_upgrade/pos/pa-po
s-oc3_install_config/paposoc3.html
Connecting the Console and Auxiliary Port Cables
This section describes how to attach a cable to the console ports or auxiliary ports on the Cisco ASR
1002-X Router. This router uses RJ-45 ports for both the auxiliary port and the console port. On the front
panel of the router, the integrated route processor console port and auxiliary port are labeled CON and
AUX, respectively.
To meet Class A emission requirements, shielded cables must be used for the console and auxiliary port
Caution
connectors.
Before using the console interface on the router via a terminal or PC, you must perform the following
steps:
Before connecting a terminal to the console port, configure the terminal to match the chassis console
Step 1
port as follows: 9600 baud, 8 data bits, no parity, 1 stop bits (9600 8N1).
Connect to the port using the RJ-45 to DB-9 cable.
Step 2
For information about how to change the default settings to meet the requirements of your terminal or
Note
host, see the
After you establish normal router operation, disconnect the terminal, if required.
Step 3
OL-13208-11
Cisco IOS Terminal Services Configuration
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
Connecting the SPA Cables
Guide.
10-29