Chapter 14
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Figure 14-71
Figure 14-71
5
1
Negative terminal
2
Positive terminal
3
Terminal block plastic cover
Remove the slotted plastic cover from the terminal block (see
Step 5
Loosen and remove the single screw on the plastic cover. The plastic cover has slots that help to slide
a.
it out diagonally from the terminal block.
Using a nut driver (7/16 size), unsrew the positive kepnut, positive cable, and the flat washer, in that
b.
order.
The terminal block houses two double-hole barrel lugs.
OL-13208-11
shows the DC power supply terminal block and plastic cover.
Cisco ASR 1013 Router DC Power Supply Terminal Block and Plastic Cover
1
2
-4 8 /- 6 0 V
4 0 A
T h is u n it
m ig h t h a v
e m o re th
a n o n e p o
w e r s u p p ly
4
3
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
Removing and Replacing the Cisco ASR 1013 Router Power Supplies
c o n n e c ti o
n . A ll c o n
n e c ti o n s m
u s t b e re m
o v
4
Plastic cover slotted area
5
Terminal block plastic cover single screw
— —
Figure
14-71).
14-97