Cisco ASR 1000 series Hardware Installation Manual page 532

Removing and Replacing the Cisco ASR 1001 Router Power Supplies
Figure 14-75
Figure 14-75
1
8
1
2
3
4
This section contains the following topics:
• Installing the AC Power Supply into Cisco ASR 1001 Router, page 14-103
• Removing AC Power Supply from the Cisco ASR 1001 Router, page 14-105
Installing DC Power Supply into Cisco ASR 1001 Router, page 14-107
•
Removing DC Input Power from the Cisco ASR 1001 Router, page 14-113
•
The covers are an integral part of the safety design of the product. Do not operate the unit without the
Warning
covers installed. Statement 1077
Warning When you install the unit, the ground connection must always be made first and disconnected last.
Statement 1046
Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Statement 1003
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
14-102
shows both the AC and DC power supplies for the Cisco ASR 1001 Router.
Cisco ASR 1001 Router AC Power Supply and DC Power Supply
3
2
10 0- 24 0
V~
5- 2A
50 -6 0H z
1
8
AC and DC power supply fasteners
AC power supply inlet
DC power supply negative (-) connection
DC power supply positive (+) connection
Chapter 14 Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
1
4 5 6
-4 8V /-6 0V
14 A
7 3 1
5 DC power supply ground symbol
6
DC power supply terminal block connection
7 AC and DC power supply handles
— —
OL-13208-11