Cisco ASR 1000 series Hardware Installation Manual page 282

Connecting Power to the Cisco ASR 1002-F Router
To use the Management Ethernet interface on the router, perform the following steps:
Insert an Ethernet RJ-45 cable into the MGMT ETHERNET port (see
Step 1
Figure 9-22
1 Management Ethernet port
Insert the other end of the RJ-45 cable into your management device or network.
Step 2
Configure the port connection to a fixed speed through the command-line interface (CLI).
Step 3
Connecting Power to the Cisco ASR 1002-F Router
Warning The covers are an integral part of the safety design of the product. Do not operate the unit without the
covers installed in empty slots. Statement 1077
Warning When you install the unit, the ground connection must always be made first and disconnected last.
Statement 1046
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Warning
Statement 1003
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
This section provides the procedures for connecting AC-input and DC input power to your Cisco ASR
1002-F Router.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
9-28
Cisco ASR 1002-F Router Integrated RP Management Ethernet Port Connector
0
Chapter 9 Cisco ASR 1002-F Router Overview and Installation
Figure
1
9-22).
OL-13208-11