Connecting The Shared Port Adapter Cables - Cisco ASR1002 Installation Manual

Connecting the Shared Port Adapter Cables

Figure 8-19
Figure 8-19
1
Insert the two screws through the holes in the grounding lug.
Step 5
Use the Number 2 Phillips screwdriver to carefully tighten the screws until the grounding lug is held
Step 6
firmly to the chassis. Do not overtighten the screws.
Connect the opposite end of the grounding wire to the appropriate grounding point at your site to ensure
Step 7
an adequate chassis ground.
This completes the procedure for attaching a chassis ground connection. Go to the following cabling
sections for information on attaching cables.
Connecting the Shared Port Adapter Cables
The instructions for connecting the cables for the shared port adapter installed in the Cisco ASR 1002
Router are contained in the respective configuration documents for each port adapter. For example, if
you are connecting the optical fiber cables for the PA-POS-OC3 port adapter, see PA-POS-OC3 Port
Adapter Installation and Configuration at the following location:
http://www.cisco.com/en/US/partner/docs/interfaces_modules/port_adapters/install_upgrade/pos/pa-po
s-oc3_install_config/paposoc3.html
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
8-28
shows how to attach the grounding lug to the chassis ground connector.
Attaching a Grounding Lug to the Chassis Ground Connector
2
1
Chassis ground connector
Chapter 8 Cisco ASR 1002 Router Overview and Installation
2
Ground symbol
OL-13208-09