Erasing Fault Memory - Skoda Octavia Workshop Manual

01
Test of vehicle systems
Select function XX
Attention
Fault memory was not interrogated
Test of vehicle systems
Fault memory is erased!
No fault recognized!
------------ 01-14 ------------
Self-Diagnosis/Electrical Test

Erasing fault memory

- Fault memory interrogated ⇒ page 01-6.
After completing interrogation of fault memo-
ry:
HELP
K Readout in display:
- Press keys 0 and 5 (the function „Erase fault
memory“ is selected with 05) and confirm
entry with the key Q.
K If the following readout appears in the display:
→
Notes:
♦ If the ignition was switched off e.g. between
interrogating and erasing the fault memory,
the fault memory is then not erased.
♦ Observe the sequence exactly, in other words
first of all interrogate the fault memory and then
erase it.
K Readout in display:
→
After this readout appears in the display, wait
about 5 seconds before the fault memory is then
erased.
The fault memory is thus erased.
- Press → key.
- Press keys 0 and 6 (the function „End out-
put“ is selected with 06) and confirm the en-
try with the key Q.
Note:
Wait about 1 minute before again interrogating
the fault memory.
- After interrogating and erasing the fault memo-
ry, carry out a road test and once again interro-
gate fault memory ⇒ page 01-6.
When the fault memory is interrogated, the fol-
lowing readout should appear:
K Readout in display:
OCTAVIA
Edition 08.98
S00.5116.54.20