Skoda Octavia Workshop Manual page 78

32
------------ ------------
Torque Converter
K
Note:
The open side of the seal points toward the gear-
box. Apply a thin film of ATF to outer circumfer-
ence and sealing lip of seal.
- Push torque converter hub through the seal
as far as the first stop onto the gearbox shaft.
- Press torque converter by hand into the
torque converter bell and turn until the studs
of the torque converter hub engage in the
driver of the pump gear and the torque con-
verter is felt to slip in.
K If the torque converter is correctly inserted, the
distance between the contact surfaces at the
bottom at the threaded bolts at the torque con-
verter and the contact surface of the torque con-
verter bell is about 22 mm.
If the torque converter is not fully inserted, this
distance is about 10 mm.
Warning!
If the torque converter is incorrectly inserted, the
driver of the torque converter or the ATF pump may
be destroyed when the gearbox is flanged to the
engine.
torque converter
OCTAVIA
Edition 04.00
S00.5116.58.20