Connect Vehicle System Tester And Interrogate Fault Memory - Skoda Fabia 2000 Workshop Manual

FABIA 2000 Inspection and Maintenance
holding the knob in the left or right position respective-
ly.
Connect vehicle system tester and inter-
rogate fault memory
The stored faults can be read out with vehicle system
tester -V.A.G 1552-, -V.A.G 1551-, or -V.A.S. 5051-.
Note
♦
The following description relates to vehicle system
tester -V.A.G 1552- using program card 6.0.
♦
The use of vehicle diagnosis, measurement and infor-
mation system -V.A.S 5051- or fault read-out scan
tool -V.A.G 1551- with the program card version 9 is
similar. (A minor deviation on the display read-out is
possible).
Special tools, test and measuring equipment and
auxiliary items required
♦
Vehicle system tester -V.A.G 1552 -
♦
Diagnostic cable -V.A.G 1551/3, 3A, 3B oder 3C-
Test conditions
•
Battery voltage at least 9 V.
•
All fuses OK.
•
Earth connections between the engine (on gearbox
housing) and body (below the battery) must be O.K.
–
Apply handbrake.
–
Gearbox: Put the lever into Neutral.
–
Automatic gearbox: Move selector lever into position
„P" or „N".
–
Fold cover open -1- in the direction of the arrow.
Connect vehicle system tester - V.A.G 1552- with appro-
priate cable.
–
Start engine and run in idle.
If the read-outs as shown in the work sequence are not
displayed, refer to the following notes:
Note
♦
If „Error in data transmission" is displayed because of
an incorrect entry, unplug cable from vehicle system
tester, plug in again and repeat all the steps.
♦
If one of the following messages appears in the dis-
play, carry out fault finding as specified in the fault
finding program at the diagnostic cable ⇒ Current
Flow Diagrams, Electrical Fault Finding and Fitting Lo-
cations, or ⇒ Operating Instructions of vehicle sys-
tem tester
Edition 09.04
S00.5301.14.20
Vehicle system test
The control unit does not respond
Vehicle system test
Fault in communication set-up
Electrical System
02
HELP
HELP
02-6
3
page