Skoda Octavia Workshop Manual page 170

38
------------ ------------
Gears/Hydraulic Control
K Fig. 1
Removing
- Knock out roll pin for engaging lever and roll
pin for detent segment only sufficiently far to
enable the shift shaft to be pulled out.
Note:
Roll pin of engaging lever may drop into the plan-
etary gear.
Inserting
- Position front of roll pins at component.
- After inserting the shift shaft, the engaging
lever and the detent segment, knock in roll
pins flush.
K Fig. 2
Do not damage printed conductor when control
valve body installed.
- Remove gearbox selector lever ⇒ page
38-23, item 33.
- Remove spring for shift segment -A-.
- Remove bolt and washer (arrow).
The washer secures the shift shaft from drifting
out.
K Fig. 3
Removing and inserting roll pins
(arrows)
Removing and installing shift shaft
with shift segment
Installing guide plate and support-
ing plate
OCTAVIA
Edition 04.98
S00.5116.53.20