Setting Drive Gear - Skoda Octavia Workshop Manual

39
------------ ------------
Final Drive/Differential
Setting
♦ Measuring device MP 3-404/7
K - Tighten tensioning bolt to 100 Nm without
dished washer and without shim.
A - Torque wrench
B - 22 mm bit
Park lock must be engaged.
- Remove tensioning bolt.
K - Measure distance between input gear and
inner race of taper roller bearing.
- Insert dial gauge and set to „0“ with a preload
of 3 mm. Note measurement (example 1.00
mm).
The thickness of the dished washer 1.50 mm
must be added to this measurement of 1.00
mm = 2.50 mm.
The specified bearing preload is achieved if the
bearing preload of 0.18 mm is deducted from
the figure obtained (dished washer + measu-
rement) of 2.50 mm.
Dished washer + measurement
- Bearing preload
= Thickness of shim
- Determine shim according to the table and
fit onto the input shaft. Table of shims
⇒ page 39-26.
- Insert axial needle bearing and attach
tensioning bolt including dished washer with
a torque of 250 Nm.
Note:
Insert axial needle bearing of input shaft before
tightening the tensioning bolt. Installation
position: flat side facing input gear.
gear
and
OCTAVIA
2.50 mm
0.18 mm
2.32 mm
Edition 03.99
S00.5116.56.20