Skoda Octavia Workshop Manual page 22

00
------------ ------------
Technical Data
♦ After removing gaskets, inspect the contact
surface on the housing or shaft for burrs or
damage related to removal operations.
♦ Coat the outer circumference and the seal-
ing lip of seals with ATF for installing.
♦ Coat O-rings with ATF for inserting in order
to avoid the rings being squashed when in-
stalled.
♦ On no account use any other lubricants in
the ATF area otherwise there is a risk of op-
erational problems with the hydraulic gear-
box control.
♦ The open side of the seals points toward the
fluid to be sealed.
♦ After installing, inspect ATF level in the final
drive and planetary gear and adjust to cor-
rect level, if necessary.
Locking elements
♦ Do not over-tension circlips, replace if nec-
essary.
♦ Circlips must be resting properly in the base
of the groove.
Nuts, bolts
♦ Slacken the bolts in the opposite direction of
the tightening sequence.
♦ Slacken and tighten nuts or bolts for attach-
ing covers and housings diagonally in stages,
if no tightening sequence is stated.
♦ Replace self-locking nuts.
♦ Clean the threads of bolts which are inserted
with locking fluid, with a wire brush and then
insert bolts with AMV 185 101 A1.
♦ The tightening torque’s stated apply to non-
oiled nuts and bolts.
OCTAVIA
Edition 03.97
S00.5116.51.20