Skoda Octavia Workshop Manual page 23

OCTAVIA
Edition 03.99
S00.5116.56.20
Technical Data
Bearings
♦ Position needle bearings with the inscribed
side (larger sheet thickness) toward the
insertion drift.
♦ Insert bearings in gearbox with ATF. Carefully
oil taper roller bearings in gearbox for friction
torque measurements, particularly up to
gearbox date of construction 26.4.1998.
♦ Do not insert taper roller bearings in gearbox
with ATF from gearbox date of construction
27.4.1998.
♦ Do not mix up the outer and inner races of
equally large bearings.
♦ Always replace all the taper roller bearings
fitted to a shaft, and use makes of one
manufacturer.
Shims
♦ Re-gauge shims with a micrometer at several
points. Different tolerances make it possible
to exactly gauge the required shim thickness.
♦ Inspect for swarf or damage. Install only
shims which are in proper condition.
Internally-toothed discs
♦ Place new internally-toothed discs in ATF for
15 minutes before installing.
Control valve body
♦ If the shift elements are scorched, the control
valve body should be replaced.
Clutches
♦ Clutches K1, K2 and K3 should be dis-
assembled only for cleaning; if individual
parts are faulty, replace clutch.
The clutches are assigned by means of the
gearbox code letters.
Self-diagnosis
♦ Before carrying out service work on the
automatic gearbox, determine the cause of
the problem as accurately as possible with
the aid of Repair Group 01 Self-Diagnosis
⇒ page 01-1.
00
------------ 00-7 ------------