Before Disassembling Final Drive - Skoda Octavia Workshop Manual

39
Setting operations when replacing individual components
When carrying out removal and installation work at the gearbox, it is only necessary to conduct a re-setting of input
gear, drive pinion with output gear or differential housing, if components which directly affect the setting of the final
drive, are replaced. Pay attention to the table below in order to avoid carrying out unnecessary setting operations:
The following must be set:
Gearbox housing
Input gear
1)
Taper roller bearing for input gear
Output gear
1)
Drive pinion
Taper roller bearing for drive pinion
Differential housing with gear
Taper roller bearing for differential,
bearing body or shim ring
Bearing supporting ring, park lock
gear or bearing cap
Always replace input gear and output gear together.
1)
------------ 39-24 ------------
Final Drive/Differential
Component to be replaced:
Differential housing
with riveted gear
⇒ page 39-30
X
X
X

Before disassembling final drive

Before the final drive is disassembled, it is
necessary to measure the actual friction torque
at the drive pinion.
Note the measurement obtained.
K Measuring actual friction torque
A - Commercially available torque gauge
0...600 Ncm
B - Wrench bit (width across flats 41 mm)
Input gear
1)
⇒ page 39-28
X
X
X
X
OCTAVIA
Drive pinion with
output gear
1)
⇒ page 39-25
X
X
X
X
X
X
Edition 03.99
S00.5116.56.20