Skoda Octavia Workshop Manual page 205

OCTAVIA
Edition 03.99
S00.5116.56.20
Final Drive/Differential
K
A - Commercially available torque gauge
0...600 Ncm
B - Wrench bit (width across flats 41 mm)
- Moisten these taper roller bearings with ATF
for inspecting the friction torque.
The friction torque of these taper roller bearings
must be 180...220 Ncm higher than the friction
torque which was measured previously at the
drive pinion.
K - Install these new taper roller bearings as
supplied, and do not oil additionally.
The friction torque of these new taper roller
bearings must be
friction torque which was measured previously
at the drive pinion.
Note:
These new taper roller bearings have a modified
friction value. If these taper roller bearings are
oiled, it is not possible to achieve the stated
friction value.
Input gear (mean value)
Friction value of input gear + drive pinion = 320 Ncm
roller
to date of
roller
date of
Ncm higher than the
39
for
for
Friction
value
= 210 Ncm
1)
= 110 Ncm
------------ 39-29 ------------