Disassembling And Assembling Atf Pump - Skoda Octavia Workshop Manual

OCTAVIA

Disassembling and assembling ATF pump

Edition 03.97
S00.5116.51.20
Gears/Hydraulic Control
1 - Piston ring
♦ Check to ensure correctly fitted
♦ Removing and installing ⇒ Fig. 2
2 - Piston ring
♦ Check to ensure correctly fitted
♦ Removing and installing ⇒ Fig. 2
3 - Piston ring
♦ Check to ensure correctly fitted
♦ Removing and installing ⇒ Fig. 2
4 - Thrust washer
5 - Piston
♦ Sealing lips are vulcanised to the pis-
♦ To remove, lift out of the impeller sup-
♦ Before inserting, moisten sealing lips
♦ Fitting location: sealing lip points to-
6 - Screw, 10 Nm
♦ and then torque a further 45°
7 - Impeller support
8 - Outer gear
♦ Manufacturer’s marking (arrow) points
♦ If outer gear is installed incorrectly, the
9 - Inner gear
♦ Large shoulder points toward impeller
10 - Housing for ATF pump
11 - O-ring
♦ Always replace
12 - Torque converter seal
♦ Removing and installing ⇒ page 32-3
⇒ Fig. 1
⇒ Fig. 1
⇒ Fig. 1
ton
port at several points with a screw-
driver
with ATF
ward impeller support
toward impeller support
ATF pump may not operate freely
when installed
support
38
------------ 38-1 ------------