Skoda Octavia Workshop Manual page 165

OCTAVIA
Edition 06.03
S00.5116.60.20
Gear/Control
Removing
- Remove ATF strainer ⇒ page 38-16.
- Unbolt bracket for plug of ribbon cable and
release plug.
K - Loosen locking screw -1- for cable ducts.
Press cable duct from inside to outside out
of the gearbox housing.
- Lever off ribbon cable from solenoid valves
with MP 3-495 in direction of arrow.
Note:
If the catch on the solenoid valves is damaged,
the slide valve body must be replaced.
- Pull cable with plug of ribbon cable through
opening.
Installing
K - Route ribbon cable in such a way that when
installing it is not kinked or twisted.
- Press individual plug until it latches onto the
solenoid valves.
- Pull plug of ribbon cable through the gear-
box housing.
- Insert cable duct and tighten locking screw
to 15 Nm.
Tightening torques
Component
Overflow tube to oil pan
ATF screw plug to oil pan
Bolt for manual slider
Locking screw for cable duct
Oil pan to gearbox housing (crosswise)
Protection plate to gearbox housing
38
Tightening
torque
2 Nm
15 Nm
4 Nm
15 Nm
12 Nm
50 Nm
------------ ------------