Skoda Octavia Workshop Manual page 156

38
Disassembling and assembling 3
bine shaft
Special tools, testers and aids required
♦ Thrust plate MP 3-406
♦ Thrust plate MP 3-407
♦ Plunger MP 3-449
♦ Assembly device MP 3-494
Notes:
Clutches -K1- and -K3- are compressed.
Pressing off -K1- and -K3- ⇒ page 37-40.
Pressing on -K1- and -K3- ⇒ page 37-40.
1 - Circlip
♦ different thicknesses
♦ mark after removing and install in
same location
2 - Thrust plate
♦ fitting position: smooth side points to
the disks
------------ ------------
Gears/Hydraulic Control
rd and 4 th gear clutch -K3- with tur-
3 - Inside disk
♦ part number ⇒ page 00-2
♦ before fitting soak new inside disk in
4 - Outside disk
♦ part number ⇒ page 00-2
5 - Thrust plate
♦ caulked to wave spring washer (Pos.
♦ insert with caulked wave spring
6 - Wave spring washer
♦ caulked with thrust plate (Pos. 5)
7 - Circlip
♦ different thicknesses
♦ removing and installing ⇒ figure 2
♦ mark after removing and install in
8 - Piston cover
♦ under great spring tension
♦ sealing lips are vulcanised on piston
♦ removing and installing ⇒ figure 2
♦ before fitting wet sealing lips with ATF
9 - Spring
♦ insert between piston and piston cover
10 - Piston
♦ sealing lips are vulcanised on piston
♦ before inserting wet sealing lips with
11 - Clutch housing with turbine shaft
♦ different heights depending on the
♦ version assigned to gearbox code let-
12 - Toroidal sealing ring
♦ always replace
♦ install ⇒ figure 4
13 - Piston ring
♦ removing and installing ⇒ figure 1
♦ check correct fit ⇒ figure 3
ATF for 15 minutes
6)
washer pointing to piston
same location
cover
ATF
number of inside and outside disks
ters
OCTAVIA
Edition 12.98
S00.5116.55.20