Disassembling And Assembling Differential - Skoda Octavia Workshop Manual

OCTAVIA
2 - Drive for speedometer sender -G22
♦ removing and installing ⇒ page 39-1
3 - Output shaft/joint flange
♦ remove before removing the differen-
tial
♦ to remove remove circlip (Pos. 31)
♦ before installing set the differential
♦ install thread to joint flange
4 - Toroidal sealing ring
♦ always replace
5 - Adjusting dial
♦ remove ⇒ figure 3
♦ if bearing is reused mark fitting loca-
tion and position on marking when in-
stalling ⇒ figure 2
♦ observe setting instructions when fit-
ting new bearings ⇒ setting differen-
tial, page 39-28
6 - Sealing ring for joint flange
♦ can be replaced with the gearbox
mounted ⇒ page 39-2
♦ remove with MP 3-418
♦ before fitting fill space between seal-
ing lips with multipurpose grease
♦ driving in ⇒ figure 1
7 - Tapered ring
♦ wider collar points to stop disk
8 - Stop disk
♦ position over pressure spring
9 - Pressure spring
10 - Joint flange
♦ before removing remove the inner
circlip on the differential bevel gear
♦ removing ⇒ figure 4
♦ installing ⇒ figure 5
♦ insert with tapered ring, stop disk and
pressure spring
11 - Disk spring
♦ curved side points outwards
12 - Circlip
13 - Closing cap
14 - Lock
Edition 12.98
S00.5116.55.20
Final Drive/Differential
15 - Screw, 12 Nm
♦ insert with locking agent AMV 185 101
A1
16 - Closing cap
17 - Circlip
18 - Disk spring
♦ curved side points outwards
19 - Joint flange
♦ before removing remove the inner
circlip on the differential bevel gear
♦ removing ⇒ figure 4
♦ installing ⇒ figure 5
♦ insert with tapered ring, stop disk and
pressure spring
20 - Pressure spring
21 - Stop disk
♦ position over pressure spring
22 - Tapered ring
♦ wider collar points to stop disk
23 - Sealing ring for joint flange
♦ can be replaced with the gearbox
mounted ⇒ page 39-2
♦ remove with MP 3-418
♦ before fitting fill space between seal-
ing lips with multipurpose grease
♦ driving in ⇒ figure 1
24 - Bearing housing, 150 Nm
♦ remove with MP 3-488
♦ when installing new bearing observe
setting instructions ⇒ setting differen-
tial, page 39-28
♦ installing ⇒ figure 6
25 - Toroidal sealing ring
♦ always replace
26 - Output shaft/joint flange
♦ remove before removing the differen-
tial
♦ to remove remove circlip (Pos. 30)
♦ before installing set the differential
♦ install thread to joint flange
27 - Differential
♦ before removing the differential re-
move the bearing housing, adjusting
dial and output shaft
♦ disassembling and assembling
⇒ page 39-19
39
------------ ------------