Power Connection - Christie Roadster S+12K Setup Manual

Installation & Setup
Table 2.1. Lens Offsets
Lens Type
(All motorized
lenses)
SXGA+ Lenses
HD Lenses
WU Lenses
NOTES: 1) Offsets are subject to
0.73:Fixed and 1.16-1.49 Zoom Lenses have less offset. Refer to Specification section, Lenses for more details.
Mounting 
Folded Optics 
2.4 Power
Connection
2-8
Offset Movement Max. Amount of Display
Above or Below Lens Center
 or   or 
 
100% 50% 1050 pixels  or 
119% 42% 1183 pixels  or 
112% 54% 1243 pixels  or 

7% centering tolerance 2) % Offset = # pixels of offset / half panel resolution x 100. 3)
There are several methods for mounting the projector. Depending on your chosen
installation, one method may be more suitable than another. In typical front and rear
screen installations the projector can be mounted to a secure and level surface, such
as a table or cart. Carts are useful when the projector has to be moved during a
presentation or from site to site. It is recommended you lock the wheels on a cart,
when it's in position, to prevent someone from accidentally moving it during a
presentation.
- The projector can also be inverted and suspended from the ceiling
CEILING MOUNT
using a specially designed ceiling mount fixture. This type of mounting is
recommended for fixed installations and for those that want the projector out of plain
view or have a limited amount of space for projector and audience. For more
information, contact your dealer.
Use only the CHRISTIE approved ceiling mount kit designed for your
projector. Refer to the installation instructions and safety guidelines
provided in the kit.
In rear screen applications (Figure 2.8) where space
behind the projector is limited, a mirror may be used
to fold the optical path. The position of the projector
and mirror must be accurately set. Consult your
dealer or Christie for details.
The North American rated line cord is provided with each projector. Ensure
that you are using a line cord that meets the appropriate rating standards.
Plug the projector's high-current line cord into the line input socket located in the
lower right corner of the rear panel of the projector, then plug the 3-pronged end of
the line cord into a grounded AC outlet. Ensure the socket outlet is installed near the
equipment and is easily accessible. Input voltage to all Roadster and Mirage models
must be capable of 200 –240 VAC. Use the proper power source and the high-
current rated line cord provided. Refer to Section 6, Specifications for all power
requirements.
Max. Amount of Display
Right or Left of Lens Center
100% 1050 pixels  or 
100% 1363 pixels  or 
100% 1478 pixels  or 
Figure 2.8. Rear Screen
Roadster, Matrix WU, Mirage S+/HD/WU Setup Guide
75%
71%
77%
020-100342-02 Rev. 1 (04-2011)