Christie Roadster S+12K Setup Manual page 22

Operation
Stacking Mounts &
Stacking Legs 
Adjustable Feet 
Filter Panel 
Lamp Door 
AC Power Input &
Monitoring 
3-2
NOTE: Optional on Mirage models.
Used for stacking up to three projectors. Refer to Section 2 for details.
Use Christie stacking mounts only.
Turn the four adjustable feet to increase or decrease height and/or tilt as needed. For
most installations the projector will likely be slightly inclined to match the screen tilt
– this reduces the amount of vertical offset required. Refer to 2.3, Projector Position
and Mounting or the Roadster, Matrix WU, Mirage S+/HD/WU User Manual for
more details.
The filter door is a louvered grille for air intake. Remove to access and replace air
filter.
The lamp door is a louvered grille for accessing and replacing the lamp module.
NOTE: Lamp replacement requires a qualified service technician.
Input Panel
The input panel wires the projector to inputs (sources) and controllers such as PCs.

COMPOSITE/S-VIDEO INPUT -
signal from devices such as VCRs.
 Accepts RGB and sync signals from devices such as computers, as
RGB INPUT -
well as composite video, S-Video or YPbPr component signals.

RS-232 SERIAL INTERFACE (WITH LOOP THROUGH) -
projectors to be remotely controlled by a computer or controller,

Allows one or more projectors to be remotely controlled by
RS-422 INTERFACE -
an RS-422 compatible computer or controller (such as the Two-Way Controller
accessory).
AC LINE CORD INPUT -
recommended by Christie. See Section 6. Before unplugging, wait until the main blower
turns off or the LCD status reads Power Off.
Model
Roadster S+12K/HD12K
Matrix WU12
Mirage HD12
Mirage WU12
Mirage S+12K
Roadster S+16K
Mirage S+14K
Mirage S+16K
Mirage HD18
Mirage WU18
Roadster S+20K/HD18K
Mirage S+20K
Do not attempt operation if the AC supply is not within the
specified voltage and power range. Use the specified line cord.
WARNING
Accepts a composite video, DVI and S-Video
Use the AC supply specified, and always use the line cord
AC Power Specifications
200-240 VAC, 50-60 Hz, max. 12 amps @ 200VAC
200-240 VAC, 50-60 Hz, max. 12 amps @ 200VAC
200-240 VAC, 50-60 Hz, max. 12 amps @ 200VAC
200-240 VAC, 50-60 Hz, max. 12 amps @ 200VAC
200-240 VAC, 50-60 Hz, max. 12 amps @ 200VAC
200-240 VAC, 50-60 Hz, max. 16 amps @ 200VAC
200-240 VAC, 50-60 Hz, max. 16 amps @ 200VAC
200-240 VAC, 50-60 Hz, max. 16 amps @ 200VAC
200-240 VAC, 50-60 Hz, max. 20 amps @ 200VAC
200-240 VAC, 50-60 Hz, max. 20 amps @ 200VAC
200-240 VAC, 50-60 Hz, max. 20 amps @ 200VAC
200-240 VAC, 50-60 Hz, max. 20 amps @ 200VAC
WARNING
Roadster, Matrix WU, Mirage S+/HD/WU Setup Guide
Allows one or more
020-100342-02 Rev. 1 (04-2011)