Christie Roadster S+12K Setup Manual page 31

Roadster, Matrix WU, Mirage S+/HD/WU Setup Guide
020-100342-02 Rev. 1 (04-2011)
Shutter
S hutter
Press and hold
S hutter
open with a single keystroke. Or press and release
(shutter on; closed) or
(useful if you are unsure of the present state). Alternatively, press
from the present on/off state. A closed shutter blanks the display (turns it to black).
Close the shutter to mute all display while maintaining access to projector functions.
Opening the shutter restores the image.
NOTES: 1) The status of the shutter is shown in the LCD display window at the rear
of the projector. 2) The shutter is open upon power-up.
Function Key
Func
IF WITHIN A MENU:
with the appropriate topic elsewhere in Section 3. For example, press
Channel Setup menu to enable deletion or copying of a channel.
IF WITHIN A PRESENTATION:
two-digit number to enable a specific color or colors in
the display (see right). For example,
display only red and green data,
all color data. Eliminating one or more colors can help
with certain diagnostics and setups, such as when
accurately overlaying one image on top of another when
stacking projectors.
DEFINING OTHER USES:
special user functions for keys 1 – 5 and 7 – 9 and others. For example,
programmed to trigger RTEs (Real Time Events) or to display custom menus. Refer
to the separate Christie Serial Communications publication.
Projector
Proj
Press to access a specific projector within a group of projectors or to confirm if
Proj
the local projector is listening. The number in the "Enter Number" window indicates
which projector is currently listening to commands, and will match the projector
number that has been defined in the Menu Preferences menu.
The "Projector" checkbox (read-only) shows whether or not the projector physically
connected to a keypad are listening to commands from that keypad. A checkmark
means that connected projector is listening; if there is no checkmark, you are
communicating with a different projector.
To control a specific projector with the keypad, enter the three-digit number assigned
to the projector you want to use. If you switch to a projector other than the one you
are currently using, the checkmark will disappear.
To broadcast to multiple linked projectors, press
entering a projector number. Keypad commands will then affect all projectors in the
chain.
briefly to toggle the internal mechanical shutter blade closed or
(shutter off; open) to guarantee the correct toggle
Using the for special tasks within the menu system is noted
Func
Press followed by a
Func
6
Func
6 7
Func
Through ASCII messaging on a PC, you can also create
followed immediately by
S hutter
S hutter
will
4
will display
and then again without
Proj Proj
Operation
to toggle
S hutter
in the
Func
can be
Func
3-11