Christie Roadster S+12K Setup Manual page 12

Installation & Setup
STEP 4 
STEP 5 
2-2
Connect the Line Cord
The North American-rated line cord is provided with each projector. Ensure
that you are using a line cord, socket and power plug that meets the
appropriate local rating standards.
Connect the projector's line cord to the AC receptacle (Roadster
S+20K/HD18K/Mirage HD18/Mirage S+20K have non-detachable line cords) at the
lower corner on the rear of the projector, and to proper AC—note the outlet must be
near the equipment and easily accessible. Use only the line cord provided with the
projector or a power cord of appropriate ratings that comply with regional standards.
(See below and refer to Section 6 – Specifications for complete details on all power
requirements).
Line cord replacement must be performed by qualified service
personnel in accordance with specific national electrical safety
regulations. For details, refer to the Service Manual and contact
 The Roadster S+12K/HD12K, Matrix WU12, and the Mirage
HD12/WU12/S+12K require 200-240 VAC, 50-60 Hz, 12 amps @ 200 VAC.
 The Roadster S+16K and the Mirage S+14K/S+16K require 200-240 VAC, 50-
60 Hz, 16 amps @ 200 VAC.
 The Roadster S+20K/HD18K/Mirage HD18/WU18/S+20K require 200-240
VAC, 50-60 Hz, 20 amps @ 200 VAC.
Do not attempt operation if the AC supply and cord are not
within the specified voltage and power range. Refer to Section 6.
Turn On the Projector and Lamp
1. On the projector, turn the power
breaker/switch on. The LCD Status
Display Window displays the
initializing window for 15 seconds,
and then indicates
POWER OFF
(Figure 2.1).
2. Using the keypad, do one of the
following:
• Press and hold briefly to
toggle the lamp on.
• Press and release
immediately by .
• Press to toggle from the
off state.
The LCD Status Display Window
will display Powering Up and
then, Power On (Figure 2.1)
while the two-digit Status/Error
Code Window will display ON.
WARNING
your dealer.
WARNING
followed
Figure 2.1. Turning on the projector
Roadster, Matrix WU, Mirage S+/HD/WU Setup Guide
020-100342-02 Rev. 1 (04-2011)