Christie Roadster S+12K Setup Manual page 24

Operation
Built-in 
Table 3.1
LED Status Display
IR Remote 
3-4
While each of the keypads provides complete control of the projector, they differ
slightly in their arrangement of keys and in which functions can be accessed directly
with a key press rather than requiring use of the menu system. You may find one
keypad more convenient than another for your specific installation and application.
NOTE: The remote keypad has a single IR protocol and can be converted to a wired
remote by connecting the cable provided with the projector to the RCA jack labeled
as on the input panel.
REMOTE
To control the projector when signals from a remote keypad cannot reach the
projector, use the projector's built-in keypad (Figure 3.2). Two nearby status
windows provide feedback indicating current status and activities of the projector,
(See Table 3.1). Because the built-in keypad has fewer keys than the remote keypad,
certain projector functions are accessible only through the menu system rather than
via a direct key. NOTE: The built-in keypad cannot be disabled.
 LED STATUS DISPLAY:
- -
On
LC
LP
SH
# #
The IR remote keypad controls the projector by way of wireless communications
from a battery-powered infrared (IR) transmitter. Use the IR remote keypad the same
way you would use a remote keypad supplied with a TV or VCR. When making key
presses, direct the keypad either toward the screen or toward the front or rear of the
projector. One of the two IR sensors on the projector will detect the signals and relay
the commands for internal processing.
NOTE: For improved reception, use an optional remote IR sensor to route the signal
via a phone cable plugged into the wired keypad port.
Figure 3.2. Built-in Keypad at Projector Rear
DESCRIPTION
AC power supplied, projector Off
Projector On
Lens calibration in progress
Lamp has reached defined "Lamp Limit" refer to 3.9 Working with
the Lamp
Closed shutter
System warning or error has occurred
Cooling down (Rotating Horizontal Bars)
Power to Off state or Powering up (segments spinning clockwise
Roadster, Matrix WU, Mirage S+/HD/WU Setup Guide
020-100342-02 Rev. 1 (04-2011)