Christie Roadster S+12K Setup Manual page 45

Ventilation 
Servicing 
Roadster, Matrix WU, Mirage S+/HD/WU Setup Guide
020-100342-02 Rev. 1 (04-2011)
Use only an AC power cord recommended by Christie. Do not
attempt operation if the AC supply and cord are not within the

Do not set or rest items on the power cord. Place the projector in an area where
the projector cord cannot be abused or damaged by persons walking on it or by
objects rolling over it.

Operate the projector at the specified voltage only. Do not overload power outlets
and extension cords as this can result in fire or shock hazards.

The projector is equipped with a three-wire plug having a third grounding pin.
This is a safety feature – if you are unable to insert the plug into an outlet contact
an electrician to have the outlet replaced. Do not defeat the safety purpose of this
grounding-type plug.
Slots and vents in the projector provide ventilation. Never block or cover these
openings. This ensures reliable operation of the projector and prevents overheating.

Do not place the projector over a radiator or heat register. The projector should
not be placed in an enclosure unless proper ventilation is provided.

Do not insert objects into the ventilation openings of the projector. They may
touch dangerous voltages or short-out components resulting in a fire or shock
hazard. Do not spill liquids of any kind into the projector. Should an accidental
spill occur, immediately unplug the projector and have it serviced by a qualified
service technician.
If any of the following conditions exist, immediately unplug the projector from the
power outlet and contact your Christie dealer.

The power cord has been damaged.

The internal cooling fans do not turn on within two minutes when the projector is
first powered up.

Liquid has been spilled into the projector.

The projector has been exposed to excessive moisture.

The projector is not operating normally or its performance has significantly
deteriorated in a short period of time.

The projector has been dropped or the shipping case (if applicable) has been
badly damaged.
Do not attempt to service the projector yourself. All servicing
must be performed by Christie accredited service technicians.
Use replacement parts that are manufacturer-approved only.
Use of any other part other than the ones specified by the
manufacturer can result in fire, electric shock or risk of personal
injury and irreparable equipment damage.
WARNING
specified voltage and power range.
WARNING
Maintenance
4-3