Christie Roadster S+12K Setup Manual page 29

Input
Roadster, Matrix WU, Mirage S+/HD/WU Setup Guide
020-100342-02 Rev. 1 (04-2011)
Input 6
Input 6
Press to display from the
Input 6
PIP is enabled, pressing this key changes the PIP source. If there are two inputs
connected here, such as if the Dual SD/HD-SDI module is installed, the second input
(B) is considered
press to access
INPUT 6

While displaying from

While displaying from any input other than the Dual SD/HD-SDI Module, press
. This switch to either
Input 6
SD/HD-SDI Module inputs (A or B) was last used. Press
from the other Dual SD/HD-SDI Module input.
Input
NOTE: Available on "Brick" rental staging – Standard IR remote.
Enter (where n = 1, 2, 3, 4, 5, 6, 7 or 8) as an alternative method for
Input n
selecting which source to display. Six source locations are identified with input
numbers on the projector's input panel. The last two, 7 and 8, require the Dual
SD/HD-SDI Module installed in either of the option slots.
If PIP is enabled,
changes the main (primary) image source.
Input PIP n
NOTE:
key behavior depends on whether or not the Display Channel List
Input
option is selected in the Menu Preferences menu. You can choose to have on-screen
feedback when you press
"blind", i.e. without on-screen feedback. Refer to Menu Preferences.
Brightness
Bright
Press to increase or decrease the amount of black in the image. Use
Bright
keys until you reach the desired level of contrast—for best results, start high and
decrease so that dark areas do not become black (i.e., "crushed"). Conversely, overly
high brightness changes black to dark gray, causing washed-out images. Refer to 3.6,
Adjusting the Image (Image Settings subsection).
NOTE: Always adjust brightness before contrast.
Contrast
Contra st
Press to change the amount of white in your images. Use
Contra st
you reach the desired level of contrast—for best results, start low and increase so that
whites remain bright but are not distorted or tinted, and that light areas do not
become white (i.e., "crushed"). Conversely, low contrast causes dim images. See 3.6
for more details.
interface module installed in the Option 2. If
INPUT 6
. If you are using the built-in keypad or the remote keypad,
INPUT 8
as follows:
INPUT 8
, press
INPUT 6
or
INPUT 6
changes the PIP (secondary) image source, and
Input n
, or you may prefer to enter the desired source location
Input
again. This switches to
Input 6
, depending on which of the Dual
INPUT 8
Input 6
Operation
.
INPUT 8
again to display
keys until
3-9