Filter Replacement - Christie Roadster S+12K Setup Manual

Maintenance

Filter Replacement

Procedure
4-8
8. CLOSE LAMP DOOR
Close the lamp door and lock its two (2) ¼-turn lock screws.
IMPORTANT: The lamp module is calibrated for maximum performance
and brightness in this projector. Do not attempt to re-align or adjust the
lamp module.
9. RECORD THE SERIAL NUMBER OF THE NEW LAMP

Plug in the projector and power it up.

In the Lamp menu, select "Change Lamp".

In the Lamp S/N text box, enter the serial number.

Press to record the number and to reset the lamp timer. The timer will now
begin to log time for the new lamp.
Lamp Hours
Lamp S/N
1. Lamp Message
2. Lamp Limit
3. Lamp Mode
4. Power
5. Intensity
6. Optical Aperture
7. Lamp History
8. Change Lamp
IMPORTANT: If you neglect to enter a serial number, the lamp timer will
not reset to "0" and will therefore be inaccurate. The lamp life limit may
then expire prematurely.

The filter located at the front side of the projector should be replaced whenever the
lamp is replaced. If you are working in an extremely dusty environment you may
want to replace the filter sooner. Use the filter provided in the Christie approved
Lamp and Filter Kit for your specific projector model (see Table 4.2).
1. TURN OFF THE PROJECTOR, COOL and UNPLUG
Before removing or installing a filter, turn off the projector and allow it to cool
for 5 minutes before unplugging.
Lamp
0
?
1000
Power
500
0
3
WARNING
Use Christie approved filters ONLY.
Roadster, Matrix WU, Mirage S+/HD/WU Setup Guide
New serial# entry
Lamp History
automatically updates
Lamp History...
S/N
Lamp S/N
5679
...and resets Lamp 1234
Hours to "0"
020-100342-02 Rev. 1 (04-2011)
Hours
1001
0