Christie Roadster S+12K Setup Manual page 27

Guide to Keypads 
Keypad Commands 
Roadster, Matrix WU, Mirage S+/HD/WU Setup Guide
020-100342-02 Rev. 1 (04-2011)
Press keys one-at-a-time; there are no simultaneous key combinations required.
1)
2) Note that three keys—Power, Shutter and OSD—press key once, See Figure 3.3.
3) Hold arrow keys down for continuous adjustment/movement in one direction. In
serial networks, pause briefly between adjustments to ensure that more distant
projectors can "keep up" with the commands.
If you press a key while the projector is still responding to the previous action,
4)
such as during power-up, the second key press may not take effect.
Specific keypad commands are explained below:
Power ON/OFF
Press and hold
press twice. Or press and release
(off) to guarantee the correct toggle (useful if you are unsure of the present state).
NOTES: 1) After powering down, the lamp cooling fan remains on for approximately
5 minutes to cool the lamp. 2) It is a good idea to avoid turning a projector back on
until it has been off for several minutes. Hot re-strikes of the lamp may reduce lamp
life.
Test
Test
Press to scroll through the projector's internal test patterns. When a test pattern
Test
is up, use
Auto
Auto
S etup
Press Auto to initiate an automated process in which the projector optimizes critical
S etup
display parameters such as size, position, pixel tracking, etc., for the current unlocked
channel. These parameters are listed in Table 3.1. An Auto Setup can save time in
perfecting a display, and you can further modify the settings as desired. NOTE: For
WUXGA models a window will display, "Do Auto Setup, all except UXGA" and "Do
Auto Setup, all except WUXGA". If your signal is UXGA, choose "Do Auto Setup, all
except WUXGA". If your signal is WUXGA, choose, "Do Auto Setup, all except
UXGA". The default is "all except WUXGA". This is only used and relevant for
analog UXGA or WUXGA.
OPTIMIZES:
Pixel Tracking
Pixel Phase
Size and Blanking
Vertical Stretch
Position
Input Levels
briefly to toggle the projector on or off with a single keystroke or
followed immediately by
to scroll through the patterns without going back to the input.
Table 3.1. Auto Setup
What an "Auto Setup" Does
SETS TO DEFAULT:
Contrast
Brightness
Auto Input Level (off)
Detail
(if video source)
Filter
Luma Delay
Operation
(on) or
3-7