Christie Roadster S+12K Setup Manual page 28

Operation
3-8
Channel
C hannel
Press to select a specific source setup (channel) defined and stored in projector
Channel
memory. Once you enter a two-digit channel number (or, if there is a list displayed,
highlight it and press
according to the numerous setup parameters defined for that channel. Note that a new
channel is automatically created if you adjust an image from a new source.
NOTE: Channel (
not the Display Channel List option is enabled in the Menu Preferences menu. You
can choose to use a scrollable list of channels when you press
to enter the desired channel number "blind", i.e., without on-screen feedback. Refer
to Menu Preferences later in this section.
Input 1
Input 1
Press to display from the data input source connected to BNCs labeled
Input 1
If PIP is enabled, pressing this key will change the PIP source.
Input 2
Input 2
Press to display from the DVI source connected to
Input 2
pressing this key will change the PIP source.
Input 3
Input 3
Press to display from the composite video source connected to
Input 3
enabled, pressing this key will change the PIP source.
Input 4
Input 4
Press to display from the S-video source connected to
Input 4
enabled, pressing this key will change the PIP source.
Input 5
Input 5
Press to display from the
Input 5
PIP is enabled, pressing this key changes the PIP source. If there are two inputs
connected here, such as if the Dual SD/HD-SDI module is installed, the second input
(B) is considered
INPUT 7.

While displaying from

While displaying from any input other than the Dual SD/HD-SDI Module, press
. This switches to either
Input 5
Module inputs (A or B) was last used. Press
Dual SD/HD-SDI Module input.
), the display will automatically change and update
) key behavior during a presentation depends on whether or
C hannel
interface module installed in the Option 1. If
INPUT 5
Press to access
INPUT 5
, press
INPUT 5
Input 5
or
INPUT 5
Roadster, Matrix WU, Mirage S+/HD/WU Setup Guide
, or you may prefer
Channel
. If PIP is enabled,
INPUT 2
INPUT 3
. If PIP is
INPUT 4
as follows:
INPUT 7
again. This switches to
, depending on which of the Dual
INPUT 7
again to display from the other
Input 5
020-100342-02 Rev. 1 (04-2011)
INPUT 1.
. If PIP is
.
INPUT 7