Christie Roadster S+12K Setup Manual page 48

Maintenance
4-6
3. OPEN THE LAMP DOOR
WARNING
Protective gear required. Wear a face
shield.
Using a #2 Phillips screwdriver, loosen
the ¼-turn lock screws (2) securing the
lamp door, which is located at the rear of
the projector below the input panel. See
Figure 4.2.
4. REMOVE LAMP RETAINING BAR
Remove the two (2) screws that secure the retaining bar along the bottom edge of
the lamp module using a #2 Phillips screwdriver. See Figure 4.3. Swing the bar
aside—it is hinged on the left.
Figure 4.3. Remove Retaining Bar
5. REMOVE THE LAMP MODULE
Firmly grasp the handle and pull the lamp module straight out of the projector.
See Figure 4.4. Discard the lamp using safe disposal/recycling practices.
Figure 4.4. Remove Lamp Module
Figure 4.2. Open Lamp Door
Roadster, Matrix WU, Mirage S+/HD/WU Setup Guide
020-100342-02 Rev. 1 (04-2011)