Christie Roadster S+12K Setup Manual page 70

System Integration
Query Command
Real Time Event
C-2
Example 1. Turn room lighting on when the projector is turned off. (Assumes a
control/automation unit is configured to turn the lights on when pin 2 of its input goes
high.)
(GIO C2 O)
(GIO 2 H)

(GIO?)
(GIO! "HHLLHLH" "OOIOOOI") Reply of pin state and configuration
(GIO? C2)
(GIO! C2 O)
(GIO? 2)
(GIO! H)

Use the serial command RTE to specify an action that is initiated at a particular time
or based on an external stimulus.
For General Purpose IO "G"
Parameter Name
P1 RTE type
P2 I/O bit
P3 Pin state
(1 Character)
(String)
P4 Commands
Example 2. Projector powers up when a switch on the external device is turned on.
(GIO C2 I)
(RTE G 2 H "(PWR 1)")
(RTE G 2 L "(PWR 0)")
Set pin #2 configuration to output
Set pin #2 to high (state)
Request the state and configuration of all pins
Request configuration for pin #2
Reply with pin #2 configuration as output
Request the state of pin #2
Reply with pin #2 state as high
Value
G (Real Time I/O Event)
1-7
H = High
L = Low
"LHXXXHL" Combine multiple inputs and
trigger occurs when all conditions are met
Any valid serial protocol command for the
device
Set pin #2 configuration as input
Power on when pin #2 set to high
Power off when pin #2 set to low
Roadster, Matrix WU, Mirage S+/HD/WU Setup Guide
020-100342-02 Rev. 1 (04-2011)